A crease on a shoe is typically caused by wear and tear, specifically from when the shoe rubs against the ground. Over time, this friction can create a permanent crease in the shoe. While it’s not necessarily a bad thing, it can be unsightly and make the shoe look old and worn out.
In many cases, leather boots like Dr. Martens develop creases over time because of the natural oils and waxes in the leather. When these oils and waxes are heated by your feet, they migrate to the surface of the leather. This migration causes the leather to stiffen, and the natural bend in the boot is accentuated, resulting in a crease.
So how to get creases out of Doc Martens? Read more as we’ll talk about this topic in today’s post.
Proven Methods Of Removing That Nasty Crease Off Your Dr. Martens
If you have a crease in your shoe, there are a few ways to try to fix it. One is to use a heat gun to temporarily stretch the leather back into place. You can also try using a damp cloth to wet the area and then use a hair dryer to heat it up and help it stretch back out. However, if the crease is really bad, you may just have to buy a new pair of shoes.
Aside from that, you can also do the ironing method, which works like the first tips we’ve shared above. First, make sure that your boots are completely dry. Then, set your iron to the highest setting and place a thin towel over the boots. Iron the boots for about 10-15 seconds and the creases should start to disappear. Be careful not to scuff or mark up your boots with the iron.
It’s also important to regularly condition the leather. This will replenish the natural oils and waxes, keeping the leather supple. When you do condition your boots, be sure to focus on the areas where creases are most likely to form: around the ankle, at the ball of the foot, and at the toe.
You can use a commercially available leather conditioner, or you can make your own by mixing one part olive oil with two parts vinegar. Apply the leather conditioner solution evenly using a soft cloth or brush. And allow it to soak in for at least 30 minutes, then wipe away any excess.
You can also try stretching the leather. First, dampen a cloth with warm water and apply it to the crease. Then, use your fingers to gently push the crease out from the inside of the boot. You can also try using a shoe stretcher or boot tree to help stretch the leather. Just be careful not to overstretch the leather, or you could end up damaging your Dr. Martens boots.
After Care Tips Once The Crease(s) Is Removed From Your Dr. Martens Boots
Once the creases are gone, it is important to take care of your Dr. Martens in order to prevent them from coming back. One way to do this is by using a protectant spray. You can either buy a protectant spray or make your own by mixing one part water with one part vinegar. Apply the spray to your shoes once a week and let them dry completely before wearing them again.
Another way to take care of your Dr. Martens is by stuffing them with newspaper after each wear. This will help to keep their shape and prevent them from becoming too wrinkled. Just make sure to remove the newspaper before wearing them again so that it doesn’t rub off on your clothes.
Finally, you can also try storing your Dr. Martens in a shoe box with crumpled-up paper. This will help to absorb any moisture and keep your shoes looking their best. Just make sure to check on them every few weeks to make sure that the paper hasn’t become too damp.
By following these tips, you can keep your Doc Martens looking great for years to come.